DSC iotega WS900UL Reference Manual page 8

Wireless security and automation system
Hide thumbs Also See for iotega WS900UL:
Table of Contents

Advertisement

Figure 2-2 Panel Bottom
1. Power cable Strain Relief
2. Access Cover for Battery, SIM Card and Reset Button
3. Speaker
Removing the Battery
1. Remove the access cover from the back of the panel.
2. Push the battery retention tab in the direction of the arrow in Figure 2-4 .
3. Lift the battery from the front, then pull up and slide out.
Figure 2-4 Battery Removal
Push tab
to
release
Installing a new battery
1. Remove the access cover from the back of the panel.
2. Insert the battery, back end first, as shown in Figure 2-4 .
3. Press the front of the battery down until the retention tab clicks into place.
4. Replace the back cover of the panel.
Note: When replacing the battery, use battery pack suitable for the application. Refer to on page 2.
Section 2: Installation
Figure 2-3 Battery Compartment
4. Battery
5. Reset button
6. SIM card
7. Tamper switch
- 5 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

Iotega ws901

Table of Contents