Installation
Adjust Drum Stops
NOTICE
To prevent pinching or damaging the seal during
drum insertion, only inflate the seal when the top
lip of the platen is at, or below, the top edge of the
drum.
The drum stops are a cam which will allow adjustment
for different types of drums.
1. Loosen the bolt in each drum stop (H) and rotate
them away from the platen.
2. Raise the ram assembly.
3. Place an empty drum on the SDU baseplate.
4. Lower the ram assembly near the top of the drum.
5. Position the drum to properly align with the
platen.
16
6. Lower the ram assembly partially into the drum
and inflate the platen seal (if applicable).
7. Rotate each drum stop to contact the drum and
tighten the drum stop bolts.
8. Deflate the platen seal (if applicable), raise the
ram assembly, and remove the empty drum.
System Setup (Pneumatic Control)
1. Connect supply air.
2. Adjust air pressure settings for control functions.
3. Adjust drum stops for use with desired drums.
4. Connect outlet fittings and hoses.
5. Perform test drum unload. See
Start and Adjust the Pump, page
System Setup (Electro-pneumatic
Control)
1. Apply power.
2. Connect supply air.
3. Adjust drum stops for use with desired drums.
4. Set SDU parameters.
System Configuration Screen, page
5. Define recipes. See
6. Connect outlet fittings and hoses.
7. Perform test drum unload.
19.
See
43.
Recipe Screens, page
31.
3A5402B