Chapter 2. Installation And Configuration; E-502 Configuration "By Default - L-Card ADC Series User Manual

Chapter 2. Installation and configuration.

2.1. E-502 configuration "by default".

E-502 comes with presets "by default" corresponding to the table below.
Configuration
Setting the resolution of the
high and low byte of DO
digital outputs on the
Analog connector
Output setting
DAC1 / +15V / AGND / NC
on Analog connector
Output setting
DAC2 / -15V / GNDD / NC
on Analog connector
"L-Card" installs this configuration using jumpers on the board
configuration explanation in subsection
Note: How to programmatically resolve the Ethernet interface, explained in p.
E-502-P-EU-D
E-502-P-EU-D-I
Programmed
control
(no jumper on
fig. 2-1 on the
left)
DAC1
(See fig. 2-1)
DAC2
(See fig. 2-1)
2.2.1 2.2.2.
,
E-502-X-U-D
Programmed control
(no jumper on fig.
on the left)
2-1
DAC1
(See fig. 2-1)
DAC2
(See fig. 2-1)
(fig.
E-502-X-U-X
E-502-X-EU-X
Programmed control
(no jumper on fig.
on the left)
NC
(See fig. 2-1)
NC
(See fig. 2-1)
2-1) – inside the pack. See
2.8
.
2-1