Resetting The Breakout Box To Factory Defaults - MC2 Audio Ti Series Operator's Manual

Resetting the Breakout box to Factory Defaults

If for any reason you need to set the unit back to its factory default settings, it is
performed as part of the start-up procedure using the "Identify" button on the
rear panel.
Power the unit up and, after one second, hold in the "Identify" button until the
blue power LED illuminates – it will then flash quickly ten (10) times to show the
reset is complete. Reboot the unit for all changes to take effect.
The following settings are returned to default values using this method:
All output channel gains set to 0dB;
All output mutes set to OFF;
Sample arte set to 48kHz;
Device Name: "Breakout Network Name Has Not Been Set!";
Channel Names: 1 = "01", 2 = "02" etc.
GPIO Config. – Input = Disabled;
GPIO Config. – Output = Disabled;
GPIO Config. – Network Master Mode = Pulse;
The network address list used when the unit is in "Network Master" mode will also
be erased.
Note that this does NOT reset the networked audio routing or have any effect on
the network audio card. Please see documentation for your particular network
card for details of how to adjust this.
Page 36 Breakout Operator's Manual