Network Master" Pulsed Mode; Network Master" Latched Mode - MC2 Audio Ti Series Operator's Manual

"Network Master" Pulsed Mode

If the Breakout box is powered up as "Network Master" and is in Pulsed Mode, the
two outer LEDs will flash 9 times during boot-up.
Operation of the GPI port in this mode is as follows:
The "Pulsed Mode" will illuminate/set the General Error (according to its
programmed requirements – see page 26) and flash/pulse the individual error
outputs each time the faulty device is addressed. In this way it can be seen if
errors are on the same device (lines will flash in unison), and how many errors
there are (more flashing is more faults!). If errors clear, the lines will stop
flashing, so no user intervention is required - no lights = no faults.

"Network Master" Latched Mode

If the Breakout box is powered up as "Network Master" and is in Latched Mode,
the two inner LEDs will flash 9 times during boot-up.
Operation of the GPI port in this mode is as follows:
The "Latched Mode" will flash the General Error at 0.5Hz and the individual error
outputs will latch on while the error exists. If errors clear, then the individual
lines will go off, but the General Error will stay flashing. A GPI input (pin 6) line
has been designated as a reset and grounding this will clear the flashing General
Error if required. If reset is pressed and errors still exist, nothing will happen.
For more information on setting swapping the modes between "Latched" and
"Pulsed" please see page 26.
Breakout Operator's Manual Page 33