Recovery Update Procedure - MC2 Audio Ti Series Operator's Manual

Recovery Update Procedure

If there was a problem during the update procedure, or ICORE is not available,
it is possible to update the Breakout box in "boot-load" mode using a basic
terminal program, provided a copy of the firmware is available.
We recommend using HyperTerminal, which is always built into Windows
is accessed via:
start All Programs
The COM port settings for the HyperTerminal session need to be set up to
correspond to the amplifier's requirements in "boot-load" mode.
Click on File Properties in the HyperTerminal window.
Press "Configure" and make sure the port settings are:
Press OK to accept these settings and then OK to close the Properties window.
Breakout Operator's Manual
Accessories Communications
This will display the connection details as below.
Change the COM port number from the default to the
appropriate one for your PC configuration.
9600 Baud, 1 Stop Bit, No Parity
TM
. This
HyperTerminal
Page 39