HIKVISION DS-2AE7232TI-A User Manual page 33

HD-TVI Speed Dome DS-2AE7232TI-A User Manual
Configuring Timing Tasks
Purpose:
A timing task is a preconfigured action that can be performed automatically at a specific date and time.
1. Move the cursor to enter the TIMING TASK submenu: MAIN MENU > DOME SETTINGS > TIMING TASK.
2. Choose the task number.
A. Move the cursor to TASK NUM and click IRIS+ to enter the editing mode.
B. Click the up/down direction buttons to select the number of the task which is to be configured.
C. Click IRIS+ again to confirm the settings and exit the editing mode.
NOTE: Up to eight time tasks can be configured.
3. Set the task status.
A. Move the cursor to ENABLE TASK and click IRIS+ to enter the editing mode.
B. Click the up/down direction buttons to set the task status as ON.
C. Click IRIS+ again to confirm the settings and exit the editing mode of this column.
NOTE: If the task action and task time have not been configured, you cannot set the status to ON.
4. Configure the task action.
A. Move the cursor to TASK ACT and click the IRIS+ to enter editing mode.
B. Click the up and down direction buttons to select the task action from preset 1 to 8, pattern 1 to 5,
patrol 1 to 10, pan scan, tilt scan, panoramic scan, day mode, night mode, zero calibrate, and
none.
C. Click IRIS+ again to confirm the settings and exit editing mode of this column.
UM THD DS-2AE7232T-x 020519NA
Figure 18, Time Task Configuration Menu
33