Programming; How To; Program A Sat3; Get Out Of Program Mode - Select Engineered Systems SAT3 User And Installer Manual

Hide thumbs Also See for SAT3:
Table of Contents

Advertisement

I C O N
K E Y
Valuable Info
Be Careful!
Installers Note
User Note
SAT3 Feature
S A T
3
U S E R
/
I N S T A L L E R
SAT3 Programming
How To Program a SAT3 (Getting into Program Mode)
T
he SAT3 can be programmed with the optional hand programmer
(OptSAT3Prgm), or it can be programmed with an ordinary Touch-Tone™
telephone. The SAT3 is designed to answer immediately and prompt (with a
beep) for the 4 digit password. SAT3 comes from the factory with all 4 digits
set to 7 (7777 is the password).
To program a SAT3, from a Touch-Tone Phone, get into programming mode by:
☺ Calling the SAT3's phone number.
☺ After 1 ring, SAT3 answers and beeps once.
☺ From your phone, key in 7777
If the password is valid you will hear two beeps.
valid, SAT3 will immediately hang up.
If you do not key in the password within 5 seconds, SAT3 hangs up.
Once the password is entered, if more than 1 minute goes by with out a key
being pressed on your phone, SAT3 will hang up.
Any programming key press error will cause SAT3 to send a long tone
(Error Tone) instead of 3 beeps (Command Accepted).
How To Get Out of Program Mode.
☺ Use your Touch-Tone™ phone to key in 999
immediately.
Example: To exit program mode, key in 999
If you simply hang up, the SAT3 cannot be used for at least one minute.
G U I D E
.
. Then SAT3 can be used
.
4
2
If the password is not

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sat3/d

Table of Contents