Table of Contents
Advertisement
I C O N
K E Y
Valuable Info
Be Careful!
Installers Note
☺
User Note
SAT3 Feature
S A T
3
U S E R
/
I N S T A L L E R
Installation of SAT3
S
AT3 Installation is simple and straightforward.
Remove the 6 tamper resistant screws with the #15 Tamper Torx™ tool provided.
Remove the door assembly
Mount the back-box to a wall or pedestal, using the gasket provided. A Template
for the mounting holes is provided toward the back of this manual on Page 19.
Bring the ground wire and the RJ-11 cable through the center hole. Seal any
penetrations with a good grade of RTV silicon sealant.
MAKE
SURE
WEATHER AND WATER INTRUSION.
Using a wire nut connect the ground wire to a 16 gauge wire that is connected
to a ground rod or a cold water earth ground.
MAKE SURE THE SAT3, AND THE SAT3 BACK BOX
ARE GROUNDED TO GOOD EARTH GROUND.
G U I D E
THE
SAT3
IS
20
4
Chapter
SEALED
AGAINST
Advertisement
Table of Contents
Need help?
Do you have a question about the SAT3 and is the answer not in the manual?
Questions and answers