Table of Contents
Advertisement
I C O N
K E Y
Valuable Info
Be Careful!
Installers Note
☺
User Note
SAT3 Feature
S A T
3
U S E R
/
I N S T A L L E R
FCC Requirements
FCC REGISTRATION NUMBERS
FCC68: XXX 00X-00000-XX-X
RINGER EQUIVALENCE: 0.0X/.0X
COMPLIES WITH PART 15 SUBPART J OF FCC RULES
1. The Federal Communications Commission (FCC) has established Rules,
which permit SAT3 to be directly connected to the telephone network.
Standardized jacks are used for these connections. This equipment should
not be used on party lines or coin lines.
2. If SAT3 is malfunctioning, it may affect the telephone lines. In this case,
disconnect SAT3 until the source of the difficulty is traced and corrected. If
this is not done, the telephone company may temporarily disconnect this
service.
3. The telephone company may make changes in its' technical operations and
procedures; if such changes affect the compatibility or operation of this
device, the telephone company is required to give adequate notice of the
changes.
4. If the telephone company requests information on what equipment is
connected to their lines inform them of:
a. The telephone number to which SAT3 is connected.
b. The ringer equivalence number.
c. The USOC jack required (RJ-11).
d. The FCC registration number.
This equipment generates and uses radio frequency energy and if not
installed and used properly, in strict accordance with the manufacturer's
instructions, may cause interference to radio and television reception. The
SAT3 has been tested and found to comply with the limits for a Class B
computing device in accordance with the specifications in Subpart J of Part
15 of FCC rules, which are designed to provide reasonable protection against
such interference in a residential installation.
FOR CANADIAN USERS: DOC # 000 0000 X
G U I D E
RADIO AND TELEVISION INTERFERENCE
23
Advertisement
Table of Contents
