Table of Contents
Advertisement
I C O N
K E Y
Valuable Info
Be Careful!
Installers Note
☺
User Note
SAT3 Feature
S A T
3
U S E R
/
I N S T A L L E R
Installation of SAT3 (Continued)
Connect the RJ-11 cable to the RJ-11 jack on the SAT3. The RJ-11 cable must be
attached to a standard telephone line with at least 25 ma of line current, or an
analog port on a PABX switch having at least 24 volts and 25ma of line current.
Re-Install the door and screw the 6 tamper resistant screws back in the front door.
Press the call button. If the SAT3 has not been programmed, it will give a brief
dial tone, and then hang up.
programmed phone number.
If the audio needs adjustment, see the following steps on adjusting audio.
Adjusting SAT3 Audio
In most cases, the factory audio adjustment should work fine, but if there are
other circumstances that require adjustment, proceed with care.
The speaker volume and microphone sensitivity interact with each other.
An extreme imbalance in adjustment can cause the SAT3 to perform
poorly, or not at all.
Remove the 6 tamper resistant screws with the #15 Tamper Torx™ tool
provided.
Remove the door assembly.
Press the call button, and while the dial tone is on (it will be on only for a few
seconds), adjust the speaker volume with a 3/32" slotted screwdriver or a slotted
alignment tool. The volume increases in the direction of the arrowhead.
The speaker volume in the SAT3 is only valid while the door assembly is in
the back box, due to resonance. After making any speaker adjustment,
place the door temporarily in the back box and listen again.
To adjust the microphone sensitivity, (this is NOT a volume adjustment) call some
one on the SAT3. After they answer, start counting and after every three counts or
so, adjust the microphone sensitivity with a 3/32" slotted screwdriver or a slotted
alignment tool. The sensitivity increases in the direction of the arrowhead.
If the sensitivity is too low the called party will not be able to hear you. If
the sensitivity is too high, you will not be able to hear the called party.
Re-Install the door and screw the 6 tamper resistant screws back in the front door.
G U I D E
If it has been programmed, it will dial the
21
Advertisement
Table of Contents
