Table of Contents
Advertisement
I C O N
K E Y
Valuable Info
Be Careful!
Installers Note
☺
User Note
SAT3 Feature
S A T
3
U S E R
/
I N S T A L L E R
SAT3 OPERATION
T
he operation of SAT3 is straight forward from the users' point of view.
Simply push the button. When the PUSH FOR HELP button is depressed,
the red CALLING light will turn on.
There will be a brief dial tone to let the user know SAT3 is starting the call.
The SAT3 MUST sense a dial tone within 6 seconds, or it will hang up, and
not automatically re-dial again.
After the button is pushed, pushing on it again, (until call is completed) is
ignored.
The audio will be disabled momentarily to keep the dialed number
confidential. After dial out, SAT3 enables the audio to let the caller hear the progress
of the call. If there is no answer, or the line is busy, or there is a circuits busy (reorder),
SAT3 will hang up. If additional numbers (up to 10 total) have been programmed,
SAT3 will automatically dial the next available phone number.
Once the dialed number has been answered, two-way conversation may begin.
Conversation may go on for whatever length of Talk Time was programmed (1 to 9
minutes or 20 minutes.) 10 seconds before SAT3 times out, it will send three beeps to
alert both caller and called party that SAT3 is about to disconnect.
Pressing a 0 before the SAT3 disconnects, will reset the timer to its
programmed value, to extend the conversation.
The called party may force SAT3 to hang up before Talk Time times out
by pressing # on the called party's phone.
If SAT3 Account Cycle Time has been set (See Pg. 6), it will transmit a 4 digit
Touch-Tone™ at the programmed intervals (anywhere from 10 to 90 seconds in 10
second increments). If Account Cycle Time was set to 00 (disabled) it will send only
when receiving a
from the called party. This is called Account on Command.
While SAT3 is transmitting its account, account tones may sometimes
interfere with conversation.
G U I D E
11
3
Chapter
Advertisement
Table of Contents
