Table of Contents
Advertisement
I C O N
K E Y
Valuable Info
Be Careful!
Installers Note
☺
User Note
SAT3 Feature
S A T
3
U S E R
/
I N S T A L L E R
SAT3 Programming Cont.
Remember, SAT3 dials locations in order, starting at the 1
a number: 10, 11, 12, etc. Pay attention to which numbers you put in which
locations, if you desire a specific calling sequence.
How To Take Out or Remove a Phone number In a
Specific Location.
☺ After getting into program mode, (see Pg. 4) use your Touch-Tone™ phone to key
in 11 followed by the location number, followed by 0, and
Example: To make the SAT3 erase the fifth phone number in memory, key in 14 0
. (Remember, the first location is 10).
the SAT3 erase all phone numbers in memory, key in
91 1
.
How To Change SAT3 Ring Time.
SAT3 can be set to ring from 10 to 90 seconds before it quits trying and hangs up.
Ring Time is in 10-second increments. The factory default Ring Time is 40 seconds.
☺ After getting into program mode, (see Pg. 4) use your Touch-Tone™ phone to key
in 44, a digit from 1 to 9, and
Example: To set the SAT3 Ring Detect from the factory default of 40 seconds to
60 seconds, key in 44 6
Do NOT set SAT3 ring time to 10 seconds, unless you have special
circumstances. In most cases, the local phone company can not connect
the SAT3 fast enough to keep the SAT3 from dialing the next stored phone
number, if Ring Time is set to 1 (10 seconds).
How To Set SAT3 Acknowledge tone.
When the SAT3 calls, if an acknowledge tone is pressed by the called party, the green
light will begin flashing. This lets the person using the SAT3 know that the phone call
was received and acknowledged.
After getting into program mode, (see Pg. 4) use your Touch-Tone™ phone to key in
42, the Touch-Tone number between 1 and 9 and
Example: To set the SAT3 Acknowledge tone from the factory default of 0 (which
is disabled) to 1 key in 42 1
G U I D E
.
.
.
8
st
location it finds
.
.
Advertisement
Table of Contents
