Activation Sequence And Delays - Pego VISION SC600 Use And Maintenance Manual

CHAP. 5 - Data programming
I2 Setting of digital input n.2
I3 Setting of digital input n.3
I4 Setting of digital input n.4
I5 Setting of digital input n.5
I6 Setting of digital input n.6
I7 Setting of digital input n.7
I8 Setting of digital input n.8
I9 Setting of digital input n.9
I10 Setting of digital input n.10
I11 Setting of digital input n.11
I12 Setting of digital input n.12
I13 Setting of digital input n.13
I14 Setting of digital input n.14
I15 Setting of digital input n.15
(*)Resetting the compressor working times by displaying the desired hour counter (Hr1,
Hr2, etc.) and simultaneously pressing the two SET (compressors and fans) keys for at
least 10 seconds. After this time the control emits a beep of confirmation of completed
operation.
The activation logic of the digital outputs is selected by parameter Seq (for both
compressors and fans).
NB c / u indicates compressors / fans parameter, i.e. t1c / U indicates both parameters T1c and t1U.
With SEq=1, the activation of digital outputs always follows the 1, 2, 3, 4, 5, 6, 7, 8, 9, 10
sequence and the 10, 9, 8, 7, 6, 5, 4, 3, 2, 1 disabling one complying with the t1C/U,
t2C/U, t3C/U, t4C/U times. If an output is not available because an alarm occurs, it will be
temporarily excluded from the sequence.
Rev. 02-18

ACTIVATION SEQUENCE AND DELAYS

USE AND MAINTENANCE MANUAL
VISION SC600
as I1
as I1
as I1
as I1
as I1
as I1
as I1
as I1
as I1
as I1
as I1
as I1
as I1
as I1
2
3
4
5
11
12
13
14
15
23
24
25
26
27
5.14
Pag. 23