Fabric Module LEDs
Fabric Module LEDs
The fabric modules are located behind the fan trays. The following table describes the possible states for each
of these LEDs.
LED
BCN/top
LED
Status/bottom
LED
Line Card LEDs
The Beacon (BCN) and Status (STS) LEDs are located on the front, toward the left side of the module. The
Link LED for each port is located between the two rows of ports. Each of the Link LEDs is a triangle pointing
to the port above or below the LED. The following table describes the possible states for each of these LEDs.
LED
BCN
Cisco Nexus 9516 NX-OS Mode Switch Hardware Installation Guide
108
Color
Status
Blue
The operator has activated this beacon (BCN) LED to identify this module
in the chassis.
Note
Off
This module is not being identified.
Green
The fabric module is operational.
Flashing red
The fabric module has a fault.
Flashing amber
The fabric module is booting up.
Off
No power is going to the fabric module.
Color
Status
Flashing blue
The operator has activated this LED to identify this module in the
chassis.
Off
This LED is not being used.
When the operator activates the BCN/top LED, the BCN LED
on the covering fan module also activates (lights).
LEDs