Fabric Module Leds; Line Card Leds - Cisco Nexus 9508 Hardware Installation Manual

Fabric Module LEDs

LED
FAN
FAB

Fabric Module LEDs

The fabric modules are located behind the fan trays.
LED
BCN/top
LED
Status/bottom
LED

Line Card LEDs

The Beacon (BCN) and Status (STS) LEDs are located on the front left of the module, and the Link LED for
each port is located between the two rows of ports (each of these LEDs is a triangle pointing to the port above
or below the LED).
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
130
Color Status
The fan tray is operational.
Green
Red One or more fans in this fan tray has failed.
Off No power is going to the fan tray. Verify that the even numbered fabric slot (FM
2, FM 4, or FM 6) behind the fan tray has one of the following in order to power
the fan tray:
• Functioning fabric module (N9K-C9508-FM, N9K-C9508-FM-E,
N9K-C9508-FM-R, or N9K-C9508-FM-S)
The fabric modules behind this fan tray are operational.
Green
Amber At least one fabric module behind this fan tray is not operating.
Off No power is going to the fabric module behind this fan tray.
Color Status
Blue The operator has activated this beacon (BCN) LED to identify this module
in the chassis.
Note
Off This module is not being identified.
Green The fabric module is operational.
Flashing red The fabric module has a fault.
Flashing amber The fabric module is booting up.
Off No power is going to the fabric module.
When the operator activates the BCN/top LED, the BCN LED on
the covering fan module also activates (lights).
LEDs