Fabric Module Leds; Line Card Leds - Cisco Nexus 9504 Hardware Installation Manual

Fabric Module LEDs

Fabric Module LEDs

The fabric modules are located behind the fan trays. The following table describes the possible states for each
of these LEDs.
LED
BCN/top
LED
Status/bottom
LED

Line Card LEDs

The Beacon (BCN) and Status (STS) LEDs are located on the front, toward the left side of the module. The
Link LED for each port is located either between the two rows of ports, or if there is a single row of ports,
placed up/down between ports. Each of the Link LEDs is a triangle pointing to the port above or below the
LED. The following table describes the possible states for each of these LEDs.
LED
BCN
Cisco Nexus 9504 ACI-Mode Switch Hardware Installation Guide
96
Color Status
Blue The operator has activated this beacon (BCN) LED to identify this module
in the chassis.
Note
Off This module is not being identified.
Green The fabric module is operational.
Flashing green First press of the ejector button has been registered
Flashing yellow The removal of the module is in progress
Flashing red The fabric module has a fault.
Flashing amber The fabric module is booting up.
Off No power is going to the fabric module.
Color Status
Flashing blue The operator has activated this LED to identify this module in the
chassis.
Off This LED is not being used.
When the operator activates the BCN/top LED, the BCN LED
on the covering fan module also activates (lights).
LEDs