Table of Contents
Advertisement
Managing the Switch
Line Card State
power-denied
active
HA-standby
standby
Use the show module [slot_number] command to display information about all the installed modules or for
the module that you specify by its slot number.
Note
This example shows how to display information about a module in a specific slot (slot 4) of the chassis.
switch# show module 4
Mod
---
4
Mod
---
4
Mod
---
4
switch#
Displaying Temperatures for a Module
You can display temperature readings for module temperature sensors by using the show environment
temperature command. System controllers, supervisors, line cards, and fabric modules have temperature
sensors with two thresholds:
• Minor temperature threshold—When a minor threshold is exceeded, a minor alarm occurs and the
• Major temperature threshold—When a major threshold is exceeded, a major alarm occurs and the following
Description
The switch detects insufficient power for a line card to power up.
This module is the active supervisor or system controller module and the switch is
ready to be configured.
The HA switchover mechanism is enabled on the standby supervisor module.
The switchover mechanism is enabled on the standby system controller module.
Ports
Module-Type
-----
----------------------------------- ------------------ ----------
36
36p 40G Ethernet Module
Sw
Hw
--------------
------
6.1(4.11)
0.1010
MAC-Address(es)
--------------------------------------
00-22-bd-f8-2a-83 to 00-22-bd-f8-2a-b6
following actions occur for all four sensors:
• Displays system messages
• Sends Call Home alerts (if configured)
• Sends SNMP notifications (if configured)
actions occur:
• For sensors 1, 3, and 4 (outlet and on-board sensors), the following actions occur:
• Displays system messages.
• Sends Call Home alerts (if configured).
Model
N9k-X9636PQ
Serial-Num
----------
SAL17257AHD
Cisco Nexus 9516 NX-OS Mode Switch Hardware Installation Guide
Displaying Temperatures for a Module
Status
ok
45
Advertisement
Table of Contents
