Huawei RP Series Install Manual page 79

HUAWEI RP100&RP200 V100R001C04B010
Upgrade Guide
Step 5 Upgrade the TE30 from a computer using UpgMaster.exe in the same way as the normal
upgrade, as shown in Figure 5-235.
Figure 5-23 Upgrading the TE30
----End
Issue 01 (2013-06-18)
According to the security policy, the bootrom system switch must be turned off. Therefore, the settings
of bootrom system switch are not saved, and you must turn it on every time you perform the forcible
upgrade.
The bootrom system has two IP addresses: the default IP address 192.168.1.1 and a static IP address
l
the same as that of the normal system. If the normal system is unavailable, use the default IP address
of the bootrom system for upgrade. In this case, connect the host and the TE30 directly, or set the
host IP address to a value that is in the same network segment as that of the TE30 and ensure that the
host and TE30 can communicate with each other. Then, upgrade the TE30 in a way the same as the
normal upgrade.
To enter the bootrom system, you must press the MODE button when the TE30 is starting.
l
The switch of the bootrom system is mandatory to improve security. After logging in to the bootrom
l
system using Telnet, you can run mc debug to change the password for debug users. The password
will be saved after power-off, but the switch status will not.
Huawei Confidential.
5 Soft Upgrade
78