Huawei RP Series Install Manual page 78

HUAWEI RP100&RP200 V100R001C04B010
Upgrade Guide
Figure 5-21 Forcible upgrade diagram
To perform a forcible upgrade:
Step 2 Restart the TE30. When the TE30 is starting, press and hold the MODE button for 3 seconds
or more to enter the bootrom system.
Step 3 Wait about 1 minute.
Startup process, OLED screen displays Booting, After a successful start, displays the default
IP address: 192.168.1.1.
Step 4 Turn on the switch of the bootrom system using Telnet or SSH command.
1.
2.
DM8148_A8-> mnt upgswitch on
The command output is as follows:
set upg switch success: ON.
If you skip this step, the error message shown in Figure 5-22 will be displayed when you
perform 0.
Figure 5-22 Upgrade failure
Issue 01 (2013-06-18)
Log in to the TE30 using Telnet or SSH.
The default user name and password for Telnet and SSH logins are both debug.
Run the following command:
NOTE
Huawei Confidential.
5 Soft Upgrade
77