Maintenance - Flymo SabreCut XT Operator's Manual

To tilt the motor unit:
-60°
-45°
-30°
-15°
0°
15°
30°
45°
60°
75°
To extend the telescopic
pipe:
3

4. MAINTENANCE

1
To clean the hedge trimmer:
For cutting at high and low level, the motor unit
an angle of 75° to – 60° in 15° increments.
1. Keep the orange button
2. Tilt the motor unit
3. Release the orange button
4
engage.
9
For cutting at high and low heights, the telescopic pipe
continuously extended by up to 45 cm.
1. Loosen the orange nut
2. Extend the telescopic pipe
3. Tighten the orange nut
0
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
2
v Before you maintain the unit, make sure that the mains
cable is disconnected and the protective cover
over the blade
DANGER! Electric shock!
Risk of injury and risk of damage to property.
v Do not clean the unit with water or with a water jet
(in particular high-pressure water jet).
1. Clean the unit with a damp cloth.
2. Clean the airflow slots with a soft brush (do not use a screwdriver).
3. Lubricate the blade
the plastic parts.
9
pressed.
4
in the required direction.
9 and allow the motor unit
0
.
3
to the required length.
0
again.
2 .
2
with a low viscosity oil. Avoid contact with
4
can be tilted at
4 to
3
can be
1 is slid
7