Carton Contents steady handle trimmer storage holder head steady handle instruction wheel manual screws x 2 screws x 4 Trimmer Head storage holder guard IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd.
ted correctly. you are sure that the entire trimmer is in a safe operating condition. 14. If the trimmer starts to vibrate abnormally, check im- 1. Use the trimmer only in daylight or good artificial light. 2. Avoid operating your trimmer in wet grass, where feasi- mediately.
Page 4
Assembly Instructions con’t Fitting the Steady Handle 1. Squeeze the lever on the steady handle (F1) 2. Attach the steady handle to product by releasing the lever and letting the handle latches fix into the slots on the Sabre Handle.(F2) 3.
How to trim and edge • WARNING • The use of eye protection is recommended. Do not lean over the trimmer whilst trimming or edging, objects may be thrown by the cutting line. Do not allow cutting head to rest on the ground. Do not overload your trimmer.
• Remember ! Your product is designed to use only nylon line with a maximum diameter of 1.5mm. Use only genuine Flymo nylon line. 1. Take approximately 10 metres of line. Insert 15mm of line into the hole in the spool (W) and wind line in the di- rection of the arrows on the top of the spool.
Maintenance • WARNING Cutting head continues to rotate after the trimmer has been switched off. Keep fingers and hands clear of the line cutter on leading edge of guard. Caring for your product After you have finished using your product follow the procedure below: 1.
A network of specialist dealers can be found in your local 3. Prepacked spares are available from most Husq- Y ellow Pages. T o obtain service on your Flymo product sim- varna UK Ltd. stockists. ply telephone or visit your local Service Centre. Should you 4.