Storage; Troubleshooting; Technical Data - Flymo SabreCut XT Operator's Manual

5. STORAGE

To put into storage:
1
Disposal:
(in accordance with
RL2012/19/EC)

6. TROUBLESHOOTING

1
Problem
Unit does not start
Unit can no longer
be stopped
Hedge is not cleanly cut
NOTE: For any other malfunctions please contact the FLYMO service department.
Repairs must only be done by FLYMO service departments or specialist dealers
approved by FLYMO.

7. TECHNICAL DATA

Telescopic Hedge Trimmer
Motor power consumption
Mains voltage / Mains frequency 230 V / 50 Hz
Strokes
Length of blade
Tooth gap of blade
Range of extension of
telescopic tube
8
The unit must be stowed away from children.
1. Disconnect the mains cable.
2
2. Clean the unit (see 4. MAINTENANCE) and slide the protective
cover 1
3. Stow the unit in a dry area where it has protection from frost.
The unit must not be added to usual household waste.
Refer to local environmental laws for discarding.
v Important: Make sure that the unit is discarded through your
municipal recycling collection centre.
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
2
v Before you troubleshoot the unit, make sure that the
mains cable is disconnected and the protective cover
is slid over the blade
Possible Cause
Mains cable not connected
or damaged.
Blade blocked.
Start button is stuck.
Blade blunt or damaged.
SabreCut XT
Art. 9670799-01
500 W
1,600 / min.
48 cm
25 mm
0 – 45 cm
over the blade 2 .
2 .
Remedy
v Connect the mains cable or if
necessary replace it.
v Remove obstacle.
v Disconnect the mains cable
and loosen start button.
v Have blade replaced by
FLYMO Service.
1