Table of Contents
Advertisement
v All connectors and cables are of splashproof construction.
They are not waterproof and must not be left outside per-
manently nor should they be submerged or immersed in
water. Do not let cable lay or trail through pools of water
or splashed with water from hose pipes.
Mains Plug:
IMPORTANT!
If the plug supplied is cut off it should be destroyed. There
is an electric shock hazard if a cut off plug is inserted into
a 13 amp socket.
1. No earth required. Our products are double insulated to EN60745
and under no circumstances should an earth be connected to any part
of the product.
2. Ensure the mains voltage suits your product
3. The normal plug fuse and household fuse only protect the electrical
equipment and are not a safeguard against electrocution.
If your product is hard wired i. e. non-detachable mains electric
cable, a conversion kit and extension cable is available from
all Approved Service Centres which can be found in your local
Yellow Pages.
3. OPERATION
To start:
1. Remove the blade cover (A).
2. There are two switch levers fitted to your hedgetrimmer (B1 / B2).
Both switch levers need to be pressed for the product to start.
To stop:
• Move hedge trimmer away from cutting area before stopping.
v To stop, release any switch lever (C).
How to use your hedge trimmer:
1. Inspect area to be cut before each use – remove objects which can be
thrown or become entangled in the cutting blades.
2. Always keep the hedge trimmer in front of your body. Hold handle firmly
with both hands and stand in a secure and stable position.
3. Allow the cutting blades to reach full speed before entering the material
to be cut.
4. Always work going away from people and solid objects such as walls,
large stones, trees, vehicles etc.
5. If blade stalls, immediately stop the hedge trimmer. Disconnect the
hedge trimmer from the power source and clear jammed debris from
the cutting blades. Inspect blades and repair or replace as needed.
Top cutting:
Use a wide sweeping motion (D). A slight downward tilt of the cutting
blades in the direction of motion gives the best cutting results.
Side cutting:
When trimming the sides of the hedge, begin at the bottom and cut
upwards (E) tapering the hedge inward at the top. This shape will expose
more of the hedge, resulting in more uniformed growth.
4. MAINTENANCE
WARNING!
Disconnect from the mains electricity supply, before attempting
any maintenance or adjustment.
Cleaning (F):
1. Using a soft brush – remove debris from all air intakes and cutting
blade.
2. Wipe over surface of your hedge trimmer with a dry cloth.
6
31460-85.960.01.indd 6
31460-85.960.01.indd 6
DANGER! Risk of physical injury!
IMPORTANT!
Risk of injury and risk of damage to the product.
v Do not clean the product with water or with a water jet
(in particular high-pressure water jet).
v Do not clean with chemicals including petrol or solvents.
Some can destroy critical plastic parts.
Lubricating the cutting blade:
For easier operation and longer life, lubricate the cutter blades before and
after use. Apply the oil so that it runs between the two blades (G).
Service Recommendations:
1. We strongly recommend that your product is serviced at least every
twelve months, more often in a professional application.
2. Always use genuine Flymo Spare Parts.
3. Pre-packed spares are available from most Flymo Approved stockists.
4. Your product is uniquely identified by a silver and black product rating
label.
5. If you have a problem with your machine contact your local
Approved Service Centre ensuring you have full details of your
product as described on the product rating label.
6. Should it be necessary for work to be carried out by your
Service Centre, it is important to take your complete machine
including cable and any extension cables used.
A network of specialist dealers can be found in your local Yellow Pages.
To obtain service on your product simply telephone or visit your local
Service Centre. Should you require service under the terms of our guaran-
tee the Service Centre will require proof of purchase.
All of the centres listed stock genuine Flymo Spare Parts.
NOTE: Our Service Repairers act on their own behalf and are
not empowered to commit or legally bind Husqvarna UK Ltd.
in any manner whatsoever.
5. STORAGE
At the end of the cutting season:
1. Clean your hedge trimmer thoroughly.
2. Check that all nuts and bolts are secure.
3. Visually inspect the hedge trimmer for any worn or damaged parts,
contact your local Service Centre if any parts require replacement.
To put into storage:
The product must be stored away from children.
• Ensure the blade cover is fitted before storage.
• Store in a dry place where your hedge trimmer is protected from
damage.
Disposal:
(in accordance with RL2012/19/EC / S.I. 2013 No. 3113)
The product must not be disposed of to normal household
waste. It must be disposed of in line with local environmental
regulations.
IMPORTANT!
Dispose of the product through or via your municipal recycling collection
v
centre.
6. TROUBLESHOOTING
Fails to Operate:
1. Is the Power Turned On?
2. Check the fuse in the plug, if blown replace.
3. Fuse continues to blow?
Immediately disconnect from the mains electricity supply and
consult your local approved Service Centre.
Cutting blade stops under load:
1. Cut at a slower pace.
2. If cutting blade still stops under load?
Disconnect from the mains electricity supply and consult your
local approved Service Centre.
07.09.21 11:05
07.09.21 11:05
Advertisement
Table of Contents
