Carton Contents Hedgetrimmer head storage holder screws x 2 blade cover instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna Outdoor Products Customer Service Department direct Telephone : 01325 300303 Fax :...
Page 3
Safety If not used properly this product can be dangerous! This product can cause serious injury to the oper- ator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product. The operator is responsible for following the warning and safety instructions in this manual and on the product.
Assembly Instructions Attatching the Hedgetrimmer to the Sabre Handle 1. Push the Hedgetrimmer head onto the Sabre Handle until you hear a click. (A1) 2. Push the Hedgetrimmer head further onto the Sabre Handle until it reaches the mark shown in Fig A2. 3.
How to Use Cutting Positions 1. To change cutting position, press the button on the hedgetrimmer head (G1) and move to the position required. • Your Product has seven different cutting positions (H), to enable high top cutting (J), side cutting etc (K). How to Use your Hedgetrimmer 1.
Caring for your Hedgetrimmer Cleaning (L) 1. Using a soft brush - remove debris from all air intakes and cutting blade. 2. Wipe over surface of your hedgetrimmer with a dry cloth. • IMPORTANT Never use water for cleaning your hed- getrimmer.
Fault Finding Hints Cutting blade stops under load Poor cut quality 1. Cut at a slower pace. 1. Ensure the product is being used correctly 2. If cutting blade still stops under load? (see How to Use) Disconnect from the Power Pack and con- 2.
Service Recommendations machine including cable and any exten- 1. We strongly recommend that your product sion cables used. is serviced at least every twelve months, more often in a professional application. A network of specialist dealers can be found 2. Always use genuine Husqvarna Spare Parts. in your local Yellow Pages.