Assembly; Operation - Flymo SabreCut XT Operator's Manual

2. ASSEMBLY

1
To assemble the telescopic
handle:
ß M
3

3. OPERATION

1
To connect the hedge
trimmer:
8
The hedger, blade, protective cover and the operation instructions
are included in the scope of delivery.
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
2 v Before you assemble the unit, make sure that the mains
cable is disconnected and the protective cover
over the blade
4
1. Slide the telescopic pipe
the stop position. Ensure that the two markings
other.
5
2. Tighten the grey nut
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
v Before you connect, adjust or transport the unit,
2
disconnect the mains cable and slide the protective
1
cover
DANGER! Risk of electric shock!
To avoid damage to the mains cable
cable
v Before you operate the unit insert the mains cable
the cable lock
v Never take hold of the protective cover
7
ing the unit.
1. Loop the mains cable
pull tight.
2. Connect the extensimainson cable
2 .
ß
3 into the motor unit
5
.
2
over the blade .
7 must be inserted into the cable lock
8 .
7
, insert the loop into the cable lock
1
M
3 5
4 until you reach
ß
face each
M
6 the mains
1 when connect-
7
into a 230 V mains socket.
is slid
8 .
7 into
8
and
5