Danfoss VLT MCA 121 EtherNet/IP Manual page 32

6 Parameters
[8] Select setup 2
[9] Select setup 3
[10] Select setup 4
NB!
The following configuration is required in order to change the set-up after a time-out:
Set par. 0-10
8-05 End-of-Timeout Function
Option:
6
[0] Hold set-up
[1] * Resume set-up
8-06 Reset Control Word Timeout
This parameter is active only when
Option:
[0] * Do not reset
[1] Do reset
8-10 Control Word Profile
Select the interpretation of the control and status words corresponding to the installed fieldbus. Only the selections valid for the fieldbus installed in
slot A will be visible in the LCP display.
For guidelines in selection of
For additional guidelines in the selection of
the installed fieldbus.
Option:
[0] * FC profile
[5] ODVA
8-13 Configurable Status Word STW
Option:
[0] No function
[1] * Profile Default
[2] Alarm 68 Only
[3] Trip excl Alarm 68
[16] T37 DI status
32
Function
defines whether to resume the set-up used before the time-out or to retain the set-up
endorsed by the time-out function.
See [7] Select setup 1
Select setup 1
See [7]
Select setup 1
See [7]
Active Set-up to [9] Multi set-up and select the relevant link in par. 0-12
Function:
Select the action after receiving a valid control word following a time-out. This parameter is active
only when par. 8-04
Retains the set-up selected in par. 8-04
par. 8-06 Reset Control Timeout
Resumes the set-up active prior to the time-out.
Hold set-up
[0] has been selected in par.8-05
Function:
Retains the set-up specified in par.8-04
time-out.
Returns the frequency converter to the original set-up following a control word time-out. The fre-
quency converter performs the reset and then immediately reverts to the
FC profile PROFIdrive profile
[0] and
PROFIdrive profile
[1],
Function:
Function:
This parameter enables configuration of bits 12 – 15 in the status word.
Function corresponds to the profile default selected in par. 8-10
Only set in case of an Alarm 68.
Set in case of a trip, except if the trip is executed by an Alarm 68.
The bit indicates the status of terminal 37.
"0" indicates T37 is low (safe stop)
"1" indicates T37 is high (normal)
MG.90.J2.02 - VLT
This Set-up Linked to
Control Timeout Function
is set to [Set-up 1-4].
Control Timeout Function
toggles. Then the frequency converter resumes its original set-up.
End-of-Timeout Function
Control Word Timeout Function
Serial communication via RS 485 Interface
[1] please refer to the
ODVA CANopen DSP 402
[5] and [7], please refer to the Operating Instructions for
®
is a registered Danfoss trademark
MCA 121 EtherNet/IP
.
and displays a warning, until
.
, following a control word
Do not reset
[0] setting
section.
Control Profile .