Ethernet/Ip - Danfoss VLT MCA 121 EtherNet/IP Manual

6 Parameters
12-22 Process Data Config Read
Range:
[[0 - 9] PCD read 0 - 9]
12-28 Store Data Values
Option:
[0] * Off
[1] Store All set-ups
12-29 Store Always
Option:
[0] * Off
6
[1] On

6.2.4 EtherNet/IP

12-30 Warning Parameter
Range:
[0000 – FFFF hex]
12-31 Net Reference
Option:
[0] * Off
[1] On
12-32 Net Control
Option:
[0] * Off
38
Function:
Configuration of readable process data.
Function:
This parameter activates a function that stores all parameter values in the non-volatile memory
(EEPROM) thus retaining parameter values at power-down.
The parameter returns to "Off".
The store function is inactive.
All parameter value will be stored in the non-volatile memory, in all four setups.
Function:
Activates function that will always store received parameter data in non-volatile memory (EEPROM).
Function:
Read only. Displays the EtherNet/IP specific 16-bit Status-word.
Bit
0 Owned
1 Not used
2 Configured
3 Not used
4 Not used
5 Not used
6 Not used
7 Not used
8 Minor recoverable fault
9 Minor unrecoverable fault
10 Major recoverable fault
11 Major unrecoverable fault
12 Not used
13 Not used
14 Not used
15 Not used
Function:
Read only. Displays the reference source in Instance 21/71.
Reference from the network is not active.
Reference from the network is active.
Function:
Read only. Displays the control source in Instance 21/71.
Control via the network is not active.
®
MG.90.J2.02 - VLT is a registered Danfoss trademark
MCA 121 EtherNet/IP
Description