2.
While holding the removable frame at the top and bottom, lift it up
an inch and then out away from the stationary frame.
3.
Locate the switches at the rear edge of the MAC board (middle
board) between the bottom two ribbon cables (Figure 4.6).
4.
Set the switch with your finger.
5.
Slide the removable frame back onto the stationary frame.
6.
Push the removable frame back to the operating position.
7.
Reconnect the green conductor for grounding the stationary frame to
the ground post on the removable frame (Figure 4.5).
Figure 4.6
MAC Board Switches
Shield
Power
Supply
MAC
Board
Board
Chapter 4
Installing the 1779 KFM Interface
Down
Host
Board
Up
4 9