Tinycontrol LAN Controller V2.0 Manual page 22

manual LAN Controller V2.0 – Firmware: HOME v. 3.13 and ISP v. 2.09 – LANKONT-002
Reading XML data
Enter the IP address and the page name eg 192.168.1.100/st0.xml
The values of the sensors should be divided by 10
Control Panel:
- Dynamic data - st0.xml
- Static data - st2.xml
Events Config: s.xml
Scheduler: sch.xml
Network Config: board.xml
Working time: s_time.xml using the Timezone
Switching sockets http request
You can arm / switch set out without clicking on the buttons in the control panel, making
use of the following commands :
IP/outs.cgi?out=xxxxx – switches set the output to the opposite of the current
IP/outs.cgi?outx=x – disable or enable a specific output
when password authentication is enabled , the command of the following form :
user:password@IP/outs.cgi?out=xxxxx
user:password@IP/outs.cgi?outx=x
Examples:
192.168.1.100/outs.cgi?out=0 – changes the output state to the opposite out0
192.168.1.100/outs.cgi?out=2 – out2 output changes state to the opposite
192.168.1.100/outs.cgi?out=02 – changes the output state out0 and out2
to the opposite
192.168.1.100/outs.cgi?out=01234 – changes the state of the outputs of out0 to out4
the opposite
192.168.1.100/outs.cgi?out0=0 – turns out out0 ( ON state )
192.168.1.100/outs.cgi?out0=1 – turns out out0 ( OFF )
192.168.1.100/outs.cgi?out1=0 – turns out out1 ( ON state )
192.168.1.100/outs.cgi?out1=1 – turns out out1 ( OFF )
192.168.1.100/outs.cgi?out4=0 – turns out out4 ( ON state )
192.168.1.100/outs.cgi?out4=1 – turns out out4 ( OFF )
22
www.tinycontrol.eu