Step 16
Slide the long drip pan into the hole in the front
panel above the syrup topping dispensers.
(See Figure 133.)
Figure 133
Step 17
Slide the two shorter drip pans into the holes in the
rear panel. Slide the two notched drip pans into the
left and right side panels. (See Figure 134.)
Figure 134
Step 18
Install the front drip tray and splash shield under the
door spouts. (See Figure 135.)
Figure 135
150415
Operating Procedures
Mix Pump Assembly
Step 1
Inspect the rubber and plastic pump parts. The
o-rings, check rings, and gaskets must be in 100%
good condition for the pump and entire machine to
operate properly. They cannot properly serve their
intended function if nicks, cuts, or holes in the
material are present.
Inspect the plastic pump parts for cracks, wear, and
de-lamination of plastic.
Replace any defective parts immediately and
discard the old.
Step 2
Assemble the piston. Slide the red o-ring into the
groove of the piston. DO NOT lubricate the o-ring.
(See Figure 136.)
Step 3
Apply a thin layer of lubricant to the inside of the
pump cylinder at the retaining pin hole end. (See
Figure 137.)
60
Figure 136
Figure 137
Model C606