Mitsubishi Electric FDF71VNXVD Technical Manual page 209

Step 7
7. Fix the heater with 4 brackets.
Step 8
8. Insert the plastic band with clip on the designated
place (2 places), and fix the heater.
Step 9
9. Lay down the wiring on the same route of fan motor wiring,
and fix the wire with attached plastic band (2 places) at the
same place where the fan motor wiring is banded.
Fan motor wiring
Heater
<Note>
Fan motor wiring is banded on
the bracket so that it doesn't
loosen.
Do not loose the band for the
motor wiring to band the heater
wire together but use the
attached plastic band.
<Note>
1) Fix the heater so that the bracket
doesn't pinch the heater as figure
shows.
Heater
✕ ✕ ✓
2) Place the heater so as to touch the
base completely.
Heater
✓
Base
✕
<Note>
1) Do not fasten the heating part with
the plastic band.
There is a marking on the end of
heating part.
Marking
✕
Step 10
10. Insert the connector to the port CnF (Black) on the top right
of the PCB, and fix the wire with bands (3 places). Excess
part of the wire should be dropped naturally.
Connector CnF
Band
(Black)
<Note>
Be sure to cut the excess
part of plastic band.
It may cause abnormal
noise when hit by fan blade
or misassembling of
panels.
Do not bundle excess part
of the wire. It may damage
the heater.
207
- -
'11 • PAC-T-160
3) In bending position, twist the heater to
make it easier to bend, and get back
to be able to fix it with bracket.
Bracket
Base
4) Be careful not to be injured by
aluminum fin when fixing the heater
with screw.
2) When the heater is laid down correctly,
the end of heating part comes to the
corner of the base.
Marking
✓
Step 11
11. Reasse
Take c
▼
<Note>
1. Tight
2. Do no
Step 12
12. Reasse
1) Fron
2) Serv
<Note>
● This heat
disconne
Drop the cable
● Be sure t
naturally
Especially
mar
It ma
Use
Use