Residual-current device
Main switch
Clip
Safety Key
Clip
Mains cable
Mains cable
Connect the mains plug of the mains cable into a socket.
The device must only be connected to a professionally
installed, earthed mains socket.
Connecting the treadmill no multiple sockets.
If an extension cable is required, then it must comply with
DIN standards, VDE regulations and guidelines, technical ru-
les issued by other European Union member states or other
states which are party to the Agreement on the European
Economic Area.
Main switch
The main switch is located next to the mains connection on the
front of the treadmill. Use the switch to turn the treadmill on or off.
Switch position „I" = treadmill switched on
Switch position „0" = treadmill switched off
Fault-Current Switch (depending on the model)
There is a fault-current button-switch next to the main switch on
the front of the motor cover to prevent the treadmill from being
damaged by electrical surges in the network. This button-switch is
triggered off by if a surge in the electrical supply occurs and acts
as a circuit breaker. In this case the treadmill will be completely
switched off. If this occurs, switch off the treadmill at the main
switch, and pull the mains cable out of the socket with the plug.
Press the button on the fault-current switch back in. Re-connect
the mains cable with the plug and switch the treadmill back on at
the main switch.
Safety Key
Safety Key
The treadmill will only operate if the safety key is correctly in
contact with contact point in the cockpit. The treadmill will stop
automatically if the safety key is no longer in contact.
Before each training session make sure to attach the safety key
to your clothing with the clip.
If you want to stop the treadmill quickly, cannot keep up with the
speed, or any other emergency arises, pull the string to remove
the safety key out of the cockpit. If the safety key is connected to
your clothing it will automatically be pulled out of the cockpit if you
fall. It is therefore vital to make sure that the clip is securely fas-
tened to your clothing and cannot somehow be pulled off. Adjust
the length of the string to hang down loosely during training.
It is not possible to operate the treadmill without the safety key
being correctly inserted. Always remove the safety key when your
treadmill is not in use to ensure that it cannot be used by any
other third party, for example by children, without your permission
or unsupervised.
The treadmill will stop automatically if the safety key is pulled out
of the cockpit during training. The incline will remain in the ad-
justed position and can only be lowered after the safety key has
been re-connected.
9
ENG
Need help?
Do you have a question about the 7.3 and is the answer not in the manual?