Table of Contents
Advertisement
In order to be able to transport your training device simply and safely, transport rollers are attached to the front
of the base frame. To transport the training device, stand behind the device and grasp the back end of the tread-
mill with both hands. The treadmill is heavy if in doubt, lift it with two persons. Now raise the exercise machine
until the weight of the training device rests on the transport rollers. Now you can easily move the machine to the
desired position on the transport rollers. Take care transporting and always make sure that you have a firm and
secure footing when lifting.
Figure treadmill similar!
Coupling for
Main Switch
Mains Cable
Residual-current device /
Fuse
Illustration may vary due to the model
To protect the treadmill from unauthorised use, always unplug the cord and keep the safety key away from the
treadmill, inaccessible to children and third parties.
Transport
Mains Cable
Connect the mains plug on the mains cable to an electrical socket.
This device is only to be connected to an earthed socket installed by a qualified
electrician. Do not use a socket strip to connect the treadmill belt. If an extension cable
is required, then it must comply with DIN standards, VDE regulations and guidelines,
technical rules issued by other European Union member states or other states which are
party to the Agreement on the European Economic Area.
Main Switch
The main switch is located next to the mains connection on the front of the treadmill. Use
this switch to turn the treadmill on and off.
Switch position "I" = treadmill turned on.
Main Switch position "0" = treadmill turned off
Fault-Current Switch (depending on the model)
There is a fault-current button-switch next to the main switch on the front of the motor
cover to prevent the treadmill from being damaged by electrical surges in the network.
This button-switch is triggered off by if a surge in the electrical supply occurs and acts as
a circuit breaker. In this case the treadmill will be completely switched off. If this occurs,
switch off the treadmill at the main switch, and pull the mains cable out of the socket
with the plug. Press the button on the fault-current switch back in. Re-connect the mains
cable with the plug and switch the treadmill back on at the main switch.
Fuse (depending on the model)
There fuse next to the main switch on the front of the motor cover to prevent the treadmill
from being damaged by electrical surges which can occur in the network. In this case
the treadmill will be completely switched off. If this occurs, switch off the treadmill at the
main switch, and pull the mains cable out of the socket with the plug. Check the fuse and
replace it if necessary. Re-connect the mains cable with the plug and switch the treadmill
back on at the main switch.
Lock Function
7
ENG
Advertisement
Table of Contents
