Removing The Front Table - Horizon Fitness PC-P430 Manual

3 Descriptions of Mechanisms

3 - 5 Removing the Front Table

3 - 5 - 1 Procedure to Remove the Front Table
■ Go through the following steps after removing the
back table.
1 Remove the right cover.
(Fig.1)
1
. Remove the right cover on the front table. (You do not
need to remove the left cover.)
Remove only the two screws shown in the drawing
of fig.1. If you remove the other screws, the micro
switch on the rear will drop.
2
. Remove the locking screw.
The collar is behind the locking screw. Be careful not
to drop the collar.
2 Remove the lower cover.
(Fig.2)
• Remove the upper four screws and the lower two
screws, and pull out the lower cover in a horizontal
direction.
3 Remove the cutting stick removing lever.
(Fig.3)
• Remove the snap ring, and pull out the cutting stick
removing lever unit.
4 Remove the counter.
(Fig.4)
• Remove the counter so that you can remove the body of
6
the Key switch in step on the next page.
1
. Push the claws on the white case outward and push out
the counter from the inside of the machine.
2
. Remove the wirings for the counter. (See page 71 for
details.)
Removing the Front Table
1
Screw
2
1
Screw
1
Fig.1 Removing the right cover on the front table
Fig.2 Removing the lower cover
Locking Screw
Right Cover
Snap Ring
404018
3_5_1A
Fig.3 Removing the cutting stick removing lever
S00
Key Switch
Lower Cover
White Case
404018
3_5_1B
Fig.4 Rmoving the counter
36
PC-P430
Cutting Stick 404018
3_5_1C
Removing Lever
White Case
Claw
Claw
Counter
A10
Counter 404018
3_5_1D