Removing The Back Table - Horizon Fitness PC-P430 Manual

3 - 4 Removing the Back Table

3 - 4 - 1 Procedure to Remove the Back Table
■ This section describes the procedure to remove the
back table.
1 Remove the knife.
2 Remove the top cover.
(Fig.1)
1
. Loosen the screw on the door and open the door.
2
. Remove the two screws on the rear of the top cover, and
remove the top cover in the upper direction.
3 Remove the rear cover, the rear right cover
and the rear left cover.
(Fig.2)
• Insert the Allen wrench into the holes in the rear right
and left covers and loosen the locking screws. The rear
right and left covers can be pulled out outward. (You do
not need to remove the screws.)
4 Remove the backgauge.
(Fig.3)
• Shims to adjust the height may be under the bracket.
(Be careful not to lose the shims.)
5 Remove the back table.
(Fig.4)
6 Lower the knife holder to the lower limit.
2 4
• Go through step to in page 9.
• Lower the knife holder to the lower limit so that the
clamp can be removed easily afterward.
• Turn off the power, and disconnect the power cable.
3
Descriptions of Mechanisms
2
Top Cover
Fig.1 Removing the top cover
Rear Cover
Rear Left Cover
Fig.2 Removing rear, rear right and rear left covers
Removing the Back Table
The shims may be
under the bracket.
2
Be careful not to lose
them.
1
Loosen this
screw and open
the door.
404018
3_4_1A
Fig.3 Removing the backgauge
Insert the 3 mm
Allen wrench into
this hole
Rear Right Cover
404018
3_4_1B
Fig.4 Removing the back table
404018
3_4_1C
Back Table
404018
3_4_1D
PC-P430
35