Removing The Backgauge Drive Section - Horizon Fitness PC-P430 Manual

3 - 9 Removing the Backgauge Drive Section

3 - 9 - 1 Procedure to Remove the Backgauge Drive Section
■ Go through the following steps after removing the cam
described in the page 40.
1 Remove the belt cover.
(Fig.1)
2 Remove the bevel gear unit.
(Fig.2)
• There are only two mounting screws.
3 Remove the timing pulley.
(Fig.3)
1
. Lower the tension pulley.
2
. Remove the timing belt.
3
. Remove the timing pulley.
4 Remove the feed screw and the guide shaft.
(Fig.4)
• You need to remove the side frame before replacing
the motor. You need to broaden out the front of the side
frame when you remove the side frame. Remove the
feed screw and the guide shaft so that you can broaden
the side frame afterward.
1
. Remove the snap ring (STW-12) on the guide shaft. The
snap ring is inside the side frame.
2
. Pull out the guide shaft to the rear.
3
. Remove the bevel gear and the ring on the rear of the
machine.
4
. Pull out the feed screw to the rear.
3
Descriptions of Mechanisms
Belt Cover
Fig.1 Removing the belt cover
Bevel Gear
Bevel Gear Unit
Fig.2 Removing the bevel gear unit
Removing the Backgauge Drive Section
404018
3_9_1A
Fig.3 Removing the timing pulley
Feed Screw
404018
3_9_1B 3 Bevel Gear
Fig.4 Removing the feed screw and the guide shaft
2
1 Tension Pulley
3 Timing Pulley
404018
3_9_1C
1
Snap Ring
STW-12
Guide
Shaft
2 2
4
Ring
404018
3_9_1D
PC-P430
41