Removing The Clamp - Horizon Fitness PC-P430 Manual

3 Descriptions of Mechanisms

3 - 6 Removing the Clamp

3 - 6 - 1 Procedure to Remove the Clamp
■ Go through the following steps after removing the
front table.
1 Disconnect the cable and the connector.
(Fig.1)
2 Remove the spring holder.
(Fig.2)
• As the knife is already lowered to the lower limit, you
can remove the spring holder easily.
There are six mounting screws. The two screws on
the front is shorter than the other four screws. When
you mount the holder spring afterward, pay atten-
tion to the length of the screws and use the screws
correctly.
3 Remove the clamp.
(Fig.3)
• Grease is applied on the guide sections on the both
ends of the clamp.
• Before you mount the clamp again, clean the guide sec-
tions and apply new grease.
Removing the Clamp
Cable for the Cut Line
LEDs
Connector for LED
Board
Fig.1 Disconnect the cable for the cut line LEDs
These two screws are shorter than
the other four screws.
S p
r i n g
H o
l d e
r
Fig.2 Removing the spring holder
Clamp
Clamp Slide Mechanism
404018
3_6_1B
Fig.3 Removing the clamp
404018
3_6_1C
38
PC-P430
404018
3_6_1D