Desktop Assembly - GE MP100 Series Service Manual

ID on
assembly
Part number
1
diagrams
1 2039793-002
2 2039793-003
3 2039793-004
4 2039793-005
5 2039793-006
6 2039793-009
7 2039793-010
8 2039793-008
not pictured 2039793-007
not pictured 2020183-006
1
These numbers are shown on the following desktop and rack-mount assemblies.

Desktop assembly

2026419-033E
NOTE
GE recommends that you assemble the devices using the new hardware (screws,
washers, etc.) provided in the FRU. Some hardware (e.g., screws with a thread
locking coating) are not intended for re-use.
NOTE
During disassembly, note the positions of wires, cables, and different sized
screws; labeling them if necessary to ensure they are replaced correctly.
Use the following table as a checklist for replacing FRUs for the CIC Pro center:
Description
FRU MP100 CPU PCB
FRU MP100 FAN
FRU MP100 DUAL SPEAKERS
FRU MP100 POWER SUPPLY
FRU MP100 SATA DRIVE CABLES
FRU MP100 120G SATA HD
FRU MP100 8G SATA FLASH DRIVE
FRU MP100 FRONT BEZEL (Desktop
unit only)
FRU MP100 HARDWARE
FRU CIC PRO 4A SB FUSES
Refer to Replacement procedures on page 9-8
in the following diagram.
Replacement and checkout procedures
Replacing the CPU PCB (mother board) on page
Replacing the fan on page
Replacing the dual speakers on page
Replacing the power supply on page
Replacing the SATA drive cables on page
Replacing the hard drive on page
Replacing the flash drive on page
Replacing the front bezel on page
Since this FRU contains screws, etc., no specific procedure
is provided.
Replacing the fuse on page
CIC Pro™
Field replaceable units (FRUs)
9-21.
9-22.
9-20.
9-19.
9-17.
9-18.
9-23.
9-22.
for a description of the parts referenced
9-14.
9-9