Toro Groundsmaster 3280-D Service Manual page 82

Installing the Engine (continued)
Diesel Engine: Service and Repairs
When installing the engine ensure that you do not damage the
engine, fuel hoses, hydraulic lines, electrical harness, radiator or
other parts.
6. Carefully lower the engine to the machine frame. Ensure that the fastener
holes of the engine brackets are aligned with the holes in the upper and lower
engine shock mounts (items 2 and 19 in
7. Secure the engine to the engine mount brackets (item 16 in
8. Install the clevis pin and cotter pin to secure the hood cable to the muffler
mount.
9. Install the hydraulic pump/transmission driveshaft; refer to
Hydraulic Pump Driveshaft (page 5–98)
Driveshaft (page 5–89).
10. Connect all the wire harness connectors to the following engine components:
A. Alternator connector and stud.
B. Oil pressure switch located near the engine oil filter.
C. Connector, fusible link connector, and positive battery cable to the starter
motor.
D. High temperature shut down switch and temperature sender located on
the water pump housing.
E. Fuel stop solenoid on the injector pump.
F. Negative battery cable to the injector pump.
G. Glow plug strip.
H. PTO clutch wire connector.
11. Use the notes that you recorded during removal, secure the wires with cable
ties in proper locations.
12. Remove all of the covers and plugs from the hoses and engine openings that
you placed while removing the engine. Connect the hoses to the engine as
follows:
A. Use the labels that you attached during removal to correctly connect the
fuel supply and return hoses to the injector pump fittings
Secure the fuel hoses with the hose clamps.
B. Connect the upper and lower radiator hoses (items 9 and 11 in
to the engine. Secure the radiator hoses with the hose clamps.
13. Connect the throttle cable to the injector pump as follows
A. Route the throttle cable to the injector pump on the engine.
B. Install the throttle cable end into the lowest hole on the injector pump
control arm. Secure the cable end with a retaining ring.
C. Position the cable under the cable clamp.
D. Adjust the throttle control; refer to
4–6).
14. Install the air cleaner assembly; refer to
15. Install the exhaust muffler to the engine; refer to
IMPORTANT
Figure
or
Adjusting the Throttle Control (page
Air Cleaner System (page
Page 4–26
28).
Figure
Installing the
Installing the Transmission
(Figure
(Figure 30):
Exhaust System (page
Groundsmaster
05138SL Rev B
28).
31).
Figure 29)
4–7).
4–9).
® 3280-D/3320