Blade Spindle
g223993
1.
Idler pulley (2 each)
2.
Drive pulley
3.
Drive belt
4.
Ribbed neck bolt (8 each per
spindle)
Removing the Blade Spindle
Cutting Units: Service and Repairs
5.
Left spindle assembly
6.
Cutting blade (3 each)
7.
Blade bolt (3 each)
8.
Anti-scalp cup (3 each)
1. Park the machine on a level surface, raise the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
Support the cutting deck so that it cannot fall accidentally.
2. Remove the belt covers from the top of the cutting deck. Remove the drive
belt from the deck pulleys; refer to the Cutting Unit Operator's Manual.
3. Remove the cutting blade (item 6 in
bolt from the spindle; refer to the Cutting Unit Operator's Manual.
Figure 296
10.
11.
Figure
Page 10–8
9.
Cutting deck
Center spindle assembly
Right spindle assembly
296), anti-scalp cup, and blade
Groundsmaster
05138SL Rev B
®
3280-D/3320