Toro Groundsmaster 3280-D Service Manual page 324

Removing the Rear Frame and Axle Assembly (continued)
Installing the Rear Frame and Axle Assembly
Chassis: Service and Repairs
8. Remove the 4 flange-head screws (item 9 in
frame and axle assembly to the machine frame.
9. Carefully move the rear frame and axle assembly from the machine.
1. Carefully position the rear frame and axle assembly to the machine frame.
Note: The flange-head screws (item 9 in
rear frame and axle assembly to the machine frame have a patch lock to
prevent the screws from loosening. When installing the rear frame and axle
to machine, either replace the flange-head screws or clean the screw threads
and apply Loctite #242 (or equivalent) to the threads of the screws.
2. Align mounting holes in the rear frame and axle assembly. Install and tighten
the 4 flange-head screws (item 9 in
axle assembly. While you tighten the screws, ensure that the mounting holes
on the rear of the frame align with the axle frame holes.
3. Secure the rear of axle frame to the machine frame with the fasteners that
were removed previously
4. If equipped with rear weight(s), attach the weight(s) to the rear of the machine.
5. On 4-wheel drive machines, position the driveshaft to the bidirectional clutch.
Secure the driveshaft to the bidirectional clutch with the 6 socket-head
screws and 6 lock washers.
6. Remove the caps or plugs that were installed to the hydraulic hoses and
fittings during the removal process.
7. Use the tags that you attached during removal to correctly connect the
hydraulic hoses to the steering cylinder.
8. Lower the machine to the ground.
9. Check the hydraulic-fluid level in the reservoir (front axle) and adjust as
necessary; refer to the Traction Unit Operator's Manual.
10. Start the engine and check for component interference as the steering wheel
is turned from lock to lock.
11. Check the rear wheel toe-in and adjust if necessary; refer to the Traction
Unit Operator's Manual.
Figure
Figure 180) to secure the rear frame and
(Figure 180).
Page 7–10
Figure 180) that secure the rear
180) used to secure the
Groundsmaster ®
05138SL Rev B
3280-D/3320