Start A Method Run - GE AKTAavant Getting Started

8.3 Start a method run

Introduction
This section describes how to start a run using a previously created method. If Column
Logbook was enabled during installation of the software, registration and selection of
individual columns is possible at method start. The Column Logbook function includes,
for example, logging of column history. For further information on column handling,
please refer to UNICORN 6 Method Manual.
Choose and start a method
The instruction below describes how to open a method and start a run.
Step
1
2
3
Getting Started with ÄKTAavant and UNICORN 6 28-9440-69 AB
Action
Open the System Control module and click the icon Open Method Navigator.
Result: The Method Navigator pane opens.
Select the method to run, and click the Run icon.
Result: The Start Protocol dialog opens.
Step through the displayed pages in the Start Protocol, add requested input
and make appropriate changes if necessary. Click Next.
8 Run a method
8.3 Start a method run
101