General information and networking
1.4 Networking
1.3.2
Handling membrane connectors
When replacing parts it can sometimes be necessary to disconnect membrane connectors
from the boards and reconnect them again.
This should be done as follows:
(1)
Figure 1-8
Unplugging the membrane connector
1. Loosen the dark clamping frame of the socket by pushing it up with your fingernails until it
engages in its upper, unlocked position (Fig. left).
2. Carefully pull off the membrane connector upward.
Plugging in the membrane connector
1. With the clamping frame in the upper position, carefully plug the membrane connector into
the socket.
2. Lock it in place by pushing down the clamping frame (Figure right).
1.4
Networking
1.4.1
System settings
1.4.1.1
Settings for SINUMERIK solution line
Range of validity
This description is valid for:
● NCU 7x0.3 PN with NCU-Basesoftware (Linux-based)
● PCU 50.5 with PCU-Basesoftware (Windows XP, Windows 7)
36
Clamping frame of socket
Removing (left) and attaching (right) a membrane connector
Operator panel front: OP 012
Manual, 09/2016, A5E36371591B