Softkey Labeling - Siemens SINUMERIK 840D sl Manual

Installation

5.4 Softkey labeling

Procedure
1. Insert the assembled components (operator panel front and PCU) from the front into the
panel cutout (see Figure 5-1 Dimension sheet for installing the OP 012 operator panel
front (Page 97)).
2. Secure the operator panel front in the panel cutout from the rear using the tension jacks by
tightening the setscrews (torque 0.4 - 0.5 Nm).
See also
Preparation for mounting (Page 97)
5.4 Softkey labeling
User-specific functions can be assigned to the horizontal and vertical softkey bars. Printed
labeling strips can be used to label the softkeys.
Blank labels are already installed on delivery.
DIN A4 films are available for making the strips (for the article number, see Chapter
Overview (Page 105)).
Note
Use the "Arial" font to format text. This font is comparable to the "Univers S57" font, used by
Siemens for the key labeling.
Procedure
1. Letter the mat side of the film using a laser printer.
2. Cut the printed labels along the preprinted lines.
3. Remove the PCU retaining screws and swing out the PCU away from the operator panel
front.
4. Insert the strips into the slots provided on the rear of the operator panel front.
5. Swing the PCU back to the operator panel and secure by tightening the screws.
If the operator panel front and PCU are dismantled, omit steps 3 and 5.
102
Operator panel front: OP 012
Manual, 09/2016, A5E36371591B