Standards And Approvals - Siemens SINUMERIK 840D sl Manual

General information and networking
1.2 Application planning
1.2.3

Standards and approvals

Approvals
CE approval
Figure 1-3
The operator panels and the safety-relevant accessories satisfy the requirements and
protection objectives of the following EC directives. The operator panels and the safety-
relevant accessories comply with the harmonized European standards (EN), promulgated in
the Official Journals of the European Community:
● 2004/108/EC "Electromagnetic Compatibility" (EMC directive)
● Directive 2006/42/EC of the European Parliament and Council of May 17, 2006, on
machinery, and Directive 95/16/EC (amendment)
SIBE Switzerland Certification Service
For the HT 2 and HT 8 units.
Figure 1-4
HT 2
The HT 2 operator panel and the safety-relevant accessories (is identified in the "Accessories"
section for the respective devices) satisfy Category 3, PL d according to EN ISO 13849-1:2008.
The safety function Enabling device for special mode control and the emergency stop button
satisfy the following requirements:
● Category 3, PL d according to EN ISO 13849-1:2008
● Requirements of EN 60204-1:2006, when complying with the safety instructions in the
relevant chapters of this documentation
HT 8
The HT 8 operator panel and the safety-relevant accessories (is identified in the "Accessories"
section for the respective devices) satisfy Category 3, PL d according to EN ISO 13849-1:2008.
The emergency stop button meets the following requirements:
● Category 3, PL d according to EN ISO 13849-1:2008
● Requirements of EN 60204-1:2006, when complying with the safety instructions in the
relevant chapters of this documentation
20
CE marking
Symbol of the certifying body
Operator panel front: OP 012
Manual, 09/2016, A5E36371591B