Sony BPU4800 Operating Instructions Manual page 31

Replay Port: Replay Port or HD Cut Out Port
Protocol Setting
VDCP Clip End Mode
Sets whether the to automatically play the next clip or
whether to stop playback upon reaching the end of a clip
during continuous playback using VDCP.
• Auto Play: Play the next clip automatically upon reaching
the end of a clip.
• Stop: Stop playback upon reaching the end of a clip if a
Play command is not received from a remote control
device.
Network tab
Makes network settings.
Network 1 (1GbE)
Sets the IP address, subnet mask, and default gateway of the
NETWORK 1 connector.
Displays the MAC address of the NETWORK 1 connector.
The following values are the factory default values.
IP Address: 192.168.0.1
Subnet Mask: 255.255.255.0
Default Gateway: 0.0.0.0
The NETWORK 1 connector IP address characters are
superimposed on SLOT3 REPLAY for a fixed time after the
unit boots.
GPIO Parallel Input Setup
Assigns the commands for the input side of the GPIO (25-pin)
connector.
A 32-byte setting can be specified for pin 1 to pin 11.
GPIO Parallel Output Setup
Assigns the commands for the output side of the GPIO
(25-pin) connector.
A 32-byte setting can be specified for pin 13 to pin 24.
For details about commands, refer to the Interface Manual.
Network 2 (1GbE)
Sets the IP address and subnet mask of the NETWORK 2
connector. The default gateway setting for Network 1 is
displayed.
Displays the MAC address of the NETWORK 2 connector.
The following values are the factory default values.
IP Address: 192.168.0.2
Subnet Mask: 255.255.255.0
Network 3 (10GbE)
When an optional 10 Gigabit network is used, this sets the IP
address, subnet mask, default gateway, and MTU.
Displays the MAC address of the 10Gb network connector.
The following values are the factory default values.
31