Page 12
English For customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Installing the Software..............7 (E) Example System Configuration ............8 (E) Specifications ..................9 (E) Overview The BKDS-2530 is an RS-422A serial interface board Support for switcher/DME timeline for connecting the DVS-2000C Digital Video Switcher operation and the DME-3000/7000 Digital Multi Effects to a personal computer.
Location and Function of Parts CPU-252 Front 1 Connector CN5 2 Switch S3 3 Switch S1 4 Connector CN3 5 Indicator D2 6 Test pin TP2 7 Test pins TP4 and TP5 8 Test pin TP3 9 Test pin TP1 0 Indicator D4 !¡...
Page 15
!£ Test pin TP6 !¢ Test pin TP7 Used to check the processor I/O port outputs. Used to check the processor I/O port outputs. Clears Connected to the buzzer. the watchdog timer Rear 1 Indicators D6 to D9 2 Switch S5 3 Switch S4 4 Connector CN7 5 Switch S2...
Location and Function of Parts 5 Switch S2 9 Jumper COP1 Controls firmware operation. Used to set the IRQ number. This setting may differ from PC to PC. Number and function 1: Selects whether or not activate do not activate 0 Indicators D14 to D16 to activate the program (normal setting)
Page 17
4 SWITCHER connector (D-sub 9-pin, RS-422A) Connect to the DVS-2000C EDITOR B connector. 5 DMEs connector (D-sub 9-pin, RS-422A) Connect to the DME-3000/7000 SWITCHER PANEL connector. 6 AUX1 to AUX3 connectors (D-sub 9-pin, RS- 422A) Unused. 7 GPI connector (D-sub 15-pin) Used to input and output trigger signals from and to external equipment.
Connection and Installation The following computer configuration is necessary to Connecting the PC Interface Unit install the BKDS-2530 and its operation software BZS-2050: The connection of the computer with the CPU-252 Computer: IBM PC/AT compatible (must be able to installed to the PC Interface Unit is shown in the figure accept full-sized expansion cards) below.
Setting up the device driver Installing the Software Install the GUI application, using the procedure The BZS-2050 Operation Software is contained on two described above under “Installing the GUI floppy disks. One contains the graphical interface GUI application”. application and the other contains device driver settings file.
Example System Configuration An example of a system using the BKDS-2530 is shown below. BKDS-2010 Switcher Control Panel SWITCHER PANEL DVS-2000C Digital Video Switcher MODEL DVS-2000C OUTPUTS PRIMARY EDITOR B INPUTS PC Interface Unit SWITCHER DMEs Personal computer SWITCHER PANEL...
Specifications Remote control connectors CPU-252 50-pin, half-pitch TERMINAL D-sub 9-pin, RS-232C Power requirements EDITOR D-sub 9-pin, RS-422A SWITCHER D-sub 9-pin, RS-422A Current consumption DMEs D-sub 9-pin, RS-422A Max. 0.5 A AUX1 to AUX3 D-sub 9-pin, RS-422A (currently Temperature range may not be used) Storage: –20°C to +60°C (–4°F to D-sub 15-pin +140°F)
Page 23
The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any...