Ricoh Type M12 Field Service Manual page 59

Code Meaning
2-29 JBIG trailing edge maker error
The machine resets itself for a fatal
2-50
FCU system error
The machine resets itself because
2-51
of a fatal communication error
Snd msg() in the manual task is an
2-53 error because the mailbox for the
operation task is full.
4-01 Line current was cut
Communication failed because of
an ID Code mismatch (Closed
4-10 Network) or Tel. No./CSI
mismatch (Protection against
Wrong Connections)
5-00 Data reconstruction not possible
5-10 DCR timer expired
Storage impossible because of a
5-20
lack of memory
5-21 Memory overflow
Print data error when printing a
5-23 substitute rx or confidential rx
message
5-25 SAF file access error
Suggested Cause/Action
• FCU defective
• Check the destination device.
• If this is frequent, update the ROM, or replace
the FCU.
• If this is frequent, update the ROM, or replace
the FCU.
• The user did the same operation many times,
and this gave too much load to the machine.
• Check the line connector.
• Check for line problems.
• Replace the FCU.
• Get the ID Codes the same and/or the CSIs
programmed correctly, then resend.
• The machine at the other end may be defective.
Replace the FCU.
• Replace the FCU.
• Temporary memory shortage.
• Test the SAF memory.
• Test the SAF memory.
• Ask the other end to resend the message.
• Replace an SD card or HDD.
• Replace the FCU.
Error Codes
57