Ricoh Type M12 Field Service Manual page 111

No Function
Original Line Resolution of TX Attachment File
0 200x100 Standard
1 200x200 Detail
2 200x400 Fine
3 300 x 300 Reserve
4 400 x 400 Super Fine
5 600 x 600 Reserve
6 Reserve
7 mm/inch
This setting selects mm/inch conversion for mail transmission.
0: Off (No conversion), 1: On (Conversion)
When on (set to "1"), the machine converts millimeters to inches for sending mail. There is no
switch for converting inches to millimeters.
Unlike G3 fax transmissions which can negotiate between sender and receiver to determine
the setting, mail cannot negotiate between terminals; the mm/inch selection is determined by
the sender fax.
When this switch is Off (0):
• Images scanned in inches are sent in inches.
• Images scanned in mm are sent in mm.
• Images received in inches are transmitted in inches.
• Images received in mm are transmitted in mm.
When this switch is On (1):
• Images scanned in inches are sent in inches.
• Images scanned in mm are converted to inches.
• Images received in inches are transmitted in inches.
• Images received in mm are converted to inches.
No Function
These settings set the maximum resolution of the
original that the destination can receive.
0: Not selected
1: Selected
If more than one of these three bits is set to "1", the
higher resolution has priority. For example, if both Bit
0 and Bit 2 are set to "1" Then The Resolution is set for
"Bit 2 200 x 400.
I-fax Switch 02 (SP No. 1-102-003)
Bit Switches - 2
Comments
Comments
109